Hi guys , just bought a new factory refurbished p3A and have only taken out of the box and tried starting it up. When I turned on the controller it wouldn’t stop beeping , I used to have a p3S but crashed that after short time of owning , so I’m a bit anxious with what’s wrong with this one. It’s probably nothing , but does anyone know what I need to do?
Also I guess I need to buy a iPhone connector cord to connect phone and controller as it came with an android connector.

How many lights illuminate on the front of the remote controller when it's powered on?

Does the beeping stop if you move either stick?

msinger Posted at 2018-10-9 01:58
How many lights illuminate on the front of the remote controller when it's powered on?

Does the beeping stop if you move either stick?

4 lights and nothing happens when I move the sticks

What do you see in DJI GO when the remote controller is connected to your mobile device?

You can connect your phone to the USB port on the back of the remote controller with any Lightning cable.

I don’t have rc cable for iPhone as it came with android connection

Don't you charge your iPhone with a Lightning cable?

God I’m stupid , yes I do . I will try that

Ok connected phone , rc and aircraft and went through activation.
The only thing it said in DJI app was calibration error move aircraft or do calibration.

Can you provide a screenshot of the error message so that I can check it on my end? Is your remote controller still beeping? If the APP requires you to calibrate, just follow the instruction on the APP. Make sure to do the calibration on a flat surface with no interference.

Will do after work

But it doesn’t make sense as it beeps with or without the aircraft on

If needed, here's a how-to video on calibrating the remote controller:

Thanks all did calibration all fixed,
Great help

If you use Litchi you need to calibrate the Rc stick and the gimbal sometimes with the Dji go3.... I had same issue and resolved fast...