stevemiller333
lvl.1
United States
Offline
|
Just wanted to start this thread to help others in the future.
I have a p3p, and so does my Dad. His was working fine until he did a firmware upgrade.
We have tried every single procedure (multiple times) to relink the bird to the rc and they will not bind.
We have resolved to send the kit back to DJI at this point so they can see what the problem is.
Hopefully they can work some magic!
Here is where I am at so far....
case #CAS-2629361-K1F8M4
Greetings,
I had been discussing my problem with my Phantom Pro 3 Professional with Teen. For health related reasons I did not proceed with the service request. I am now going to send it in for repair.
Like I told Teen, my aircraft was functioning properly prior to the firmware update. I then tried the requested procedures and sent photos as he asked. I tried to request servie online but it would not work. Attached is a photo of the label on the box which includes the serial numbers. I purchased this drone online about two years ago from BuyDig. It has always worked properly until the update. After that the aircraft will not link to the RC. I find it difficult to beleive that the problem could be anything but firmware or damage caused by doing the update.
|
|