Charmande
lvl.3
Flight distance : 299459 ft
Offline
|
DroneAway Sweden Posted at 9-14 07:55
Yes that's working, thanks!! now the motors going like crazy when I hit the throttle. every time i going to fly it start cutting gras and making a round ditch!
A few things you need to check.
1. Look to see if your flight controller is mounted with the ARROW printed on the board facing FORWARD. If it is not you can either rotate it so the arrow is facing forward OR you can go into betaflight on the configuration tab on the right side and change its orientation. You should be able to pick up the drone and move it and the 3D model shown on the SETUP tab should reflect accurately how you are moving it.
2. Make sure your flight controller has proper vibration dampening (ie. it's mounted in a manner that will not allow it to shake a lot - rubber standoffs and O-rings help with this)
3. Ensure your motors are spinning in the correct direction. REMOVE THE PROPS, plugs the drone into betaflight, add your battery, go to the motors tab and then accept the warning on the right and slide the master motor tab up a lil until all motors are spinning. I rest my finger on the top of the nut on each motor to ensure my finger rotates the direction the motor is supposed to spin. If they are not remap the motors using CLI commands (youtube Joshua Bardwell motor resource remap he has an excellent video on the subject). Below is the normal motor rotation for most quads.
|
|