Connor116
New
United States
Offline
|
Howdy all!
So to make it short and sweet, I am planning out a drone build that can carry a human passenger (A bit crazy I know). I have sourced the motors/props/flight controller/etc. and have picked the configuration of the 8 motors I will be using. Unfortunately, the configuration of the motors on this multirotor design is rather uncommon, and flight controllers like the DJI Naza (which I will be using) don't support this type of configuration (Octo colinear X configuration, Picture attached).
My question is this, would I be able to use two DJI Naza flight controllers at once, outputting to one receiver? The way I plan on doing this is to connect 4 motors to one f/c and the other 4 motors to the other f/c. I will then use a Y connector to connect both f/c to one channel in my receiver.
I would like to know if anyone thinks this would work? I have heard that there is the possibility that the flight controllers may work against each other which is what I am worried about. Though I am not sure how likely this is to happen.
Any and all advice/info is greatly appreciated!
Blue skies,
- Connor
|
|