I was self-modding the remote controller to mount new antennas (4Hawks Raptor SR) and after I was done and put everything back together, my remote controller refused to turn on.
In fact at the moment the remote controller is completely lifeless. No amount of button pressing results in a reaction. If I plug in charging cable then only the two-leftmost LEDs light up but nothing else happens.

Im willing to write it off as my mistake as I wasnt particularly careful when doing the disassembly but where do I even get a replacement controller?
I have already contacted DJI support (#2529617) but havent heard back yet.

0. Disassemble and check again all you have correctly connected or not,

Remove and insert again all plug-in connections.


1. On YouTube there is a video about the features of turning on the remote after turning off the battery. I just don't remember where it was...


2. Buy from those who had lost the drone.


3. Or here MT1SS5

Hi Cihan, sorry to read and knew about the troubles you've had with your Remote Controller. We'll forward and seek the attention of the designated team for further assistance. Your patience is highly appreciated. Thank you!

Alevpi Posted at 1-5 10:46
0. Disassemble and check again all you have correctly connected or not, watch again the video disassembly

Remove and insert again all plug-in connections.

Can I use FCC model (MR1SS5) remote with a CE model drone (MR1SD25)?

ninjate Posted at 1-5 12:20
Can I use FCC model (MR1SS5) remote with a CE model drone (MR1SD25)?

No, you can't!
But you can ask the seller, perhaps he may have a remote CE version, or try to look for a remote on other sites.

Did you figure this out?  I am have almost the same problem :/

waukeenahbob Posted at 10-14 05:28
Did you figure this out?  I am have almost the same problem :/

Yeah, DJI service offered me a replacement within warranty.

Alevpi Posted at 1-5 10:46
0. Disassemble and check again all you have correctly connected or not, watch again the video disassembly

Remove and insert again all plug-in connections.

I have a very similar problem... have looked and looked for youtube video that talks about turning on the remote after battery replacement but cannot find it.  Any advice would be GREATLY appreciated!