DJI Support
Administrator
Flight distance : 2408 ft
Hong Kong
Offline
|
Overview:
- Date: 2020.01.13
- Air Unit Firmware: v01.00.03.00
- Goggles Firmware: v01.00.03.00
- Remote Controller Firmware: v01.00.03.00
- DJI Assistant 2 (DJI FPV Series): v2.0.2
What’s New?
- Added support for Air Unit (Lite).
- Added on-screen display for remote controller signal strength.
- Optimized custom on-screen display of goggles by updating center point icon.
- Optimized settings for flight controller protocol. After setting the protocol between the air unit and flight controller, the air unit no longer needs to be restarted.
- Optimized on-screen display of goggles in certain situations after customizing the on-screen display settings.
- Fixed rare issue: public channel was displayed incorrectly after enabling custom on-screen display on goggles.
Notice:
- Restart the air unit, goggles, and remote controller once the update is complete.
- Make sure that the firmware of the air unit, the goggles and the remote controller are in the same version. Check the firmware version in Setting, Device Info, and then Device Info on goggles.
- If the firmware update fails, restart the device and DJI Assistant 2 (DJI FPV Series), and try updating again.
- Update the Air Unit (Lite) when there is good ventilation. Make sure that both the goggles and remote controller are powered off before updating the Air Unit (Lite). DO NOT touch the Air Unit (Lite) during update since the temperature rises. If update fails, wait for the Air Unit (Lite) to cool down and try to update again.
|
|