Hi all

I want to use a servo motor controlled by the PWM outputs of the Matrix 210 RTK V2.

But I'm having a number of problems:

1) PWM servomotors use a voltage ranging from 4.8 to 6 Volts, while the Matrix 210 (it is also written in the manual) uses a voltage on the PWM pins of 3.3 Volt

2) On the manual I find written: "PWM power level is 3.3V and all pins can be configured in DJI Pilot app". But this is not possible, or at least, after updating the Pilot app a few days ago, I can't find any way to configure any pins.

Can anyone give me a tip?

Or can you tell me where to find information?

I have searched the web and in this forum but have not found anything.

My servo motor expects to be updated every 20 ms with a pulse between 1 ms and 2 ms.

Duty cycle is a 50 Hz waveform.
With a 1.5 ms pulse, the servo motor will be at the natural 90 degree position.
With a 1 ms pulse, the servo will be at the 0 degree position.

With a 2 ms pulse, the servo will be at 180 degrees.

But I have not results: the servomotor does not move!

Thank in advance who will want to help me.

Best regards,

Simone

Go into the camera view while connected to the drone.
Then click on the three dots in the top right.
Then under flight controller settings (picture of the drone selected) scroll down and click Extended IO Options.