DJI Digital FPV Image Transmission System Supports Betaflight OSD Information Custom Display

The DJI Digital FPV Image Transmission System finally has a firmware update, which includes support for Betaflight’s 28 OSD custom displays. The firmware has been updated for the first time, and a simple tutorial on how to customize OSD information was also written below for your reference.

  

Before setting up OSD displays, separately connect the air unit, goggles, and remote controller to DJI Assistant 2 (DJI FPV Series), and then upgrade the firmware to v01.00.05.00.

  

Note: Ensure the UART of the image transmission module is connected normally to the flight controller (the voltage on the air unit can be seen in the lower right corner of the DJI FPV Goggles display).

  

1: Connect the flight controller to the Betaflight configurator. After entering the configurator, you first need to turn on OSD in the “Settings” page.

2: Click on “OSD”, select the supported OSD elements in the menu, drag them to where you want them to display on the screen, and then click “Save”.

3: Turn on “Custom OSD” in the DJI FPV Goggles “Display” menu, and then the custom OSD information will be visible.

DJI’s latest firmware supports a total of 28 OSD custom displays. I summarize them in the table below. You can set them up based on your own needs.

For GPS settings, refer to this document: https://oscarliang.com/gps-mini-quad

DJI Digital FPV Image Transmission System Supports Betaflight OSD Information Custom Display

The DJI Digital FPV Image Transmission System finally has a firmware update, which includes support for Betaflight’s 28 OSD custom displays. The firmware has been updated for the first time, and a simple tutorial on how to customize OSD information was also written below for your reference.

  

Before setting up OSD displays, separately connect the air unit, goggles, and remote controller to DJI Assistant 2 (DJI FPV Series), and then upgrade the firmware to v01.00.05.00.

  

Note: Ensure the UART of the image transmission module is connected normally to the flight controller (the voltage on the air unit can be seen in the lower right corner of the DJI FPV Goggles display).

  

1: Connect the flight controller to the Betaflight configurator. After entering the configurator, you first need to turn on OSD in the “Settings” page.

2: Click on “OSD”, select the supported OSD elements in the menu, drag them to where you want them to display on the screen, and then click “Save”.

3: Turn on “Custom OSD” in the DJI FPV Goggles “Display” menu, and then the custom OSD information will be visible.

DJI’s latest firmware supports a total of 28 OSD custom displays. I summarize them in the table below. You can set them up based on your own needs.

For GPS settings, refer to this document: https://oscarliang.com/gps-mini-quad