I had my air unit mounted on a glider, and after a flight I noticed that one of the antennas had fallen off. Now there is no connection to the air unit and it runs VERY hot after just a few seconds.
I would assume that on an expensive unit like DJI FPV there would be some kind if thermal runaway fuse that would prevent a bricked unite due to loss of antnna?
Espcially because the antennas doesnt hold very well to the receiver.

The light on the receiver is solid red, and I cant bind(re-bind) I could how ever see the unit when connected via USB, but only for a while.

Any ideas, suggenstions?

/peter

Hi,
I too am having this issue as well. I just setup an air unit, bound it to the receiver. Setup the flight controller, Rebooted a few times and then went to activate the air unit but it wouldn't connect to usb. I then saw a solid red with a solid green as well. I tried powering on with the bind button pressed to see if that would reset it. I've let the air unit cool down to try again. nothing works.

Any suggestions?

Has there been an answer to this issue yet ?!?