happyjack70
lvl.1
United States
Offline
|
Hello Good People,
I don't normally post here, but a warm greetings to you from Southern California.
My question is setting the rth to go to the remote control.
For example: next month, I will be at the desert and wanted active tracking to follow my car off highway. When I set the rth via remote control (for it to come back to the remote control) on the spark, I then want to drive 1 mile from the departure area and have my spark, when its batteries are low, to go to that new area 1 mile away from where it took off. My question is: how many times do I press the rth to remote control button before I arrive at my destination (in case the batteries die it needs to know to come to my remote since I'm driving away from the departure point)? Should I be driving with the remote control on my lap and pressing the rth to come to my remote every few minutes or so (no worries, it's out in the desert and there's no one). The remote control is being used via my samsung and the cable that connects the phone to the remote control. I don't want the spark to fly back to its departure area, but to where my car arrives 1 mile away *from* the departure area.
My beginner mode is off.
Thank you for any tips or information coming this way.
Sincerely,
Jack
|
|