userdei
lvl.2
Poland
Offline
|
After attaching Zenmuse x5 to Matrice 600 pro as shown in this film:
https://www.youtube.com/watch?v=m-3lCGM-E1Y
every seed fine, I had a vision from the camera on DJI GO on ipad and I could move the gimbal.
Later I tried to install the new firmware to zenmuse like shown here:
https://www.youtube.com/watch?v=skjGKVTI2VM
There was no specific reaction from Zenmuse, no unusual sounds
so I thought it ignored the new firmware file.
After this, unfortunately, I don't have a camera view anymore.
on android one frame appears and then the vision is grayed out or disappears completely.
Zenmuse x5 is fine, I connected it back to OSMO Pro and it works well but with matrice no.
|
|