The self calibration of the follow focus endpoints causes a very notieceable shaking in the footage, due to the quite low sensitivity of the servo encoder.  High forces are transfered to the camera body when the motor hits those limits, causing the camera assembly to twist and bend.

It would be be very useful to manually set the end points of the focus throw, to set a "safe range" that works in between the very limit of the camera lens. This way no more shaking is expected.  In other words, if self calibration goes from 0% to 100%, I'd lilke my focus range to go for example from 2% to 98%.


Is this possible, or will it be possible in future updates?

Thanks

The self calibration of the follow focus endpoints causes a very notieceable shaking in the footage, due to the quite low sensitivity of the servo encoder.  High forces are transfered to the camera body when the motor hits those limits, causing the camera assembly to twist and bend.

It would be be very useful to manually set the end points of the focus throw, to set a "safe range" that works in between the very limit of the camera lens. This way no more shaking is expected.  In other words, if self calibration goes from 0% to 100%, I'd lilke my focus range to go for example from 2% to 98%.


Is this possible, or will it be possible in future updates?

Thanks