Hello! I am trying to use the Raveneye system, but I'm not too sure about how to go about that because it's telling me to "Turn on motors to recenter gimbal". Am I missing something?

Thanks for your help in advance,
V.

i think your cabling from Raveneye to the Ronin is not correct. make sure the cable rom the raveneye (single port on the side not the one were the HDMI is) is connected back to the lower third port on the Ronin.

Hi, im facing the same issue. I have the cables connected to the usbc port with the wifi logo.

Hello! Thank you for your feedback (first poster above) - I checked and you were right

Poster below him:

Yup! You’ll notice that on the Raveneye there are two ports on one side and one port on the other - Connect the L-shaped end of the (20mm USB-C) cable to that end of the Raveneye, then connect the other end to the bottom of the three ports in a row on the right hand side of the gimbal.

Good luck! It should work now!

ah! it works now. thanks to both of you.