Sometime at the beginning of the video the picture is weavy... do somenone knows why and is there a solution to that.This is started 3-4 days after i received my PHANTOM 3 PRO.
See the video:
Filmed in 3840x2160p 30fps but resized in 1080p

I have the same issue and some people say that it is all about shutter speed (i.e need to have ND filters to stop it) and others have said that it is an issue with prop balance.

I guess it would be at least one of those but I am no expert on the subject.

Col.

Whats your shutter speed? looks like it could be a possible shutter speed issue

that is no shutter speed !!! this is VERY BAD vibration that you need to find the source of.  Did you install the extra two gimbal savers ? if so remove them, as there should only be two.

Willie Wonka Posted at 2015-7-24 12:43
that is no shutter speed !!! this is VERY BAD vibration that you need to find the source of.  Did yo ...

I did install the 2 extras gimbal savers.... i though i lost 2 because of a miner crash. I'l remove those and let you know if it solve this issue... Thanks!

Drone vibration nothing to do with shutter speed

As said above, nothing to do with shutter speed but with the automatic stabilisation of the recording footage. Somehow your drone is pushing harder at some point (wind, missing gimbal savers,...). Had the same problem, found out one or two of those savers were missing.

alexassenmacher Posted at 2015-7-24 15:29
As said above, nothing to do with shutter speed but with the automatic stabilisation of the recordin ...

There should only be 2 savers installed from factory. This can cause the jello effect.

Willie Wonka Posted at 2015-7-24 12:43
that is no shutter speed !!! this is VERY BAD vibration that you need to find the source of.  Did yo ...

Ok... i removed the 2 extras gimbal savers and the jello effect is gone! Thanks again!