Has anyone had any issues updating an XT2 to the V01.00.03.50 firmware?  I'm not having any success and DJI tech support is asking where the exiting formware came from that was on the XT2 direct from the dealer.


Any help is appreciated.


Dennis Fisher

Hi Dennis I am having the same problem. I even tried to force the update but it did nothin.
Update:Support were not very helpful with this but I have figured it out.. Within the firmware pack there are firmwares for camera 1 and camera 2 on the XT2.  

It seems as though Camera 2 is not used on a  M200 / M210 v1, and so if the firmware is applied whilst attached to a v1, camera 2 is not upgraded.

SymptomsThis will work fine on a v1, but once attached to a v2 you not be able to use the XT2, non of the menu functions will work.You will see a notification in DJI Pilot:
"Zenmuse XT2 camera firmware to low, Please update to the latest firmware." If you try to upgrade the firmware that is already applied, the upgrade log will tell you it is already up to date.  

Goto About in DJI Pilot and you will see all firmware versions DO NOT MATCH match those listed in release notes.

Solution The answer is to attach the XT2 to a v2 and force a firmware upgrade to the latest version.

upport will tell you there is no way to do this, however there is!   
Download the lates firmware AND release notes from: https://www.dji.com/uk/zenmuse-xt2/downloads
Pay attention to versions listed in Release notes
Copy the latest firmware bin file to the root of your sd card.
Create a new file using notepad named 'ZENMUSE_XT2_FW_DEBUG'.
Ensure this file does not have an extension, eg txt, bin etc
The file should be empty (no contents)   

Insert the sd card into slot 1 of the XT2 (furthest away from the lens).
Power on the M200 /M210 v2

The presence of the DEBUG file will force the XT2 to reapply the firmware  
The upgrade takes approximately 5 minutes.
You will notice a series of beeps. Also take note of the led flashing within the sd card slot on the XT2  

Be patient, upgrade takes a few minutes!
During upgrade you should hear 3 different types of beep to notify the progress of the update:

Beep        Description DDDDDD-DDDDDD...        bin file detected, update ready to start (WAIT)
D-- D-- D-- D--....        Upgrade in progress. LED will flash blue. (WAIT)
D-DD--- D-DD---...        Upgrade complete. LED will flash green.

Power off the drone, remove the sd card and opn on your PC
Look for the file: XT2_UPGRADE_LOG.txt
This will have details of the upgrade.
Look for the following text:  
########## XT2 Upgrade Log ########## Find PackFirmware
Prepare to upgrade
Make Sound Start
Make Sound Upgrading  
..
..
..
+++ Upgrade Operate SUCCESS +++
Make Sound Finish
######## XT2 Upgrade Log End ########   

Move or delete all files from the sd card
Place sd card back into XT2 slot 1
Power up the drone
Connect the controller
Goto About in DJI Pilot and you will see all firmware versions will match those listed in release notes.   

For Firmware: v01.00.03.50 / 2020.05.08
You should see:
Gimbal: v00.02.06.48
Znemuse XT Camera 1: v01.00.00.34
Znemuse XT Camera 12  v06.02.20.00     

This was the one response from a post that i have tried for the Mtrice 300 but nothing