Setup:

Car Rigged RS2 - A7IV / 18-105 OSS

The rig works fine and I have run this application before without any issue. The rig sits nicely behind the vehicle and drafts so there is little wind turbulence.



I have the camera setup with raven's eye running joystick controls through my Tilta Wireless handle. I notice it was jerking real hard when panning and on bumps it would seem like it overcompensated. I balanced, reset, balanced, auto tuned, etc. Put on hypersmooth, took it off. It actually got worse with hypersmooth on.

https://www.dropbox.com/s/p5szzw0prrbekbq/CB-Colored-GatewayBronco01-MessedupClip.mp4?dl=0

Please help... I have had multiple successful shoots, but this one just completely ruined my day. I got a few good clips, but it could have been an amazing shoot had it not gone bad. I know 100% it's the gimbal. I just don't know what may be wrong... it has worked flawlessly before.

Setup:

Car Rigged RS2 - A7IV / 18-105 OSS

The rig works fine and I have run this application before without any issue. The rig sits nicely behind the vehicle and drafts so there is little wind turbulence.



I have the camera setup with raven's eye running joystick controls through my Tilta Wireless handle. I notice it was jerking real hard when panning and on bumps it would seem like it overcompensated. I balanced, reset, balanced, auto tuned, etc. Put on hypersmooth, took it off. It actually got worse with hypersmooth on.

https://www.dropbox.com/s/p5szzw0prrbekbq/CB-Colored-GatewayBronco01-MessedupClip.mp4?dl=0

Please help... I have had multiple successful shoots, but this one just completely ruined my day. I got a few good clips, but it could have been an amazing shoot had it not gone bad. I know 100% it's the gimbal. I just don't know what may be wrong... it has worked flawlessly before.