I drove 3 hours this morning to meet with a client to work on a sunrise hyperlapse with him and was utterly SHOCKED to learn that the new firmware REMOVES the ability to vary the exposure settings during any type  of hyperlapse.

These settings would include ISO, SHUTTER, and APERTURE.   For those not familiar with this, if you want to capture a proper hyperlapse during times of day (sunrise / sunset) when the light is continously changing, you need the ability to vary exposure manually.  This is also called "holy grail" type time lapses.

Anyways, this is extremely disappointing and I need to find a way to revert back to the old firmware, as this prevents me from doing most of the work I do with this drone.

CONCLUSION:  The new Mavic 3 firmware removes the ability to adjust exposure settings (ISO, F-stop, Shutter) when a hyperlapse is in progress.

I'll also be contacting DJI today and keep everyone posted.

Daniel (Philadelphia, PA)

Visit my Instagram Page

Hopefully, DJI can correct this issue quickly.

I took a look at your instagram and that is some exceptional work Daniel.

Hope so too.

Thank you!!
Dan

Theres no official way to go backwards,   if you use one of the hacks you will get lots of GPS errors as was reported on the forum the other day.   

PhillyDrone Posted at 6-3 04:02
Hope so too.

Thank you!!

You're very welcome Dan.    Hope you have a great weekend.

I haven’t taken a hyperlapse yet with the new firmware but hope all goes well.

Really nice work!  I hope DJI fixes this quickly!