Hello,

I have a DJI M300 RTK and wanted to ask, if it is possible to kill the  propellers without using the OSDK / Flight Controller (kill switch  function).

I know that there is a CDC for that, but I was afraid that problems with the Flight Controller or OSDK will cause interruptions / interferences
so that the CDC will not be properly executed.

Or is the CDC a safe way to kill the motors mid-air in case of an  emergency, in other words, the propellers will stop no matter what?

Thank you!

CDC is the way you kill motoros in the mid-air

Leofuica Posted at 6-17 09:25
CDC is the way you kill motoros in the mid-air

Will it work under any circumstances?

I have an onboard-computer attached to the M300 RTK and it takes control over it by sending waypoint missions. Also sometimes the pilot cannot control the drone fully, e.g. during obstacle detection.

I am looking for a 100% reliable way to kill the motors under any circumstances.
Thank you

droneflyingisfu Posted at 6-20 01:24
Will it work under any circumstances?

I have an onboard-computer attached to the M300 RTK and it takes control over it by sending waypoint missions. Also sometimes the pilot cannot control the drone fully, e.g. during obstacle detection.

OSDK FTS or HW modification, for close too 100% you need a separate system from C2C.