I want to know about
1. When I use waypoint - mode and then I switch off my transmitter or signal lost How do Phantom+2 work after that?
2. When my Phantom arrived each Waypoints, Can I control it to spin for take a photo around my waypoints?

Thanks
Phisitphong from Thailand

The Phantom will continue following the waypoints without any input from you.  You cannot take control and circle around each waypoint.  The camera will always be pointing to the next waypoint.  Once it gets to the last waypoint, it will land.  The only control you will have is pointing the camera from horizontal to vertical, assuming you have a connection to the Phantom.

It means that The Phantom can fly follow all waypoints without transmitter?

phisit2738@gmai Posted at 2014-12-2 10:05
It means that The Phantom can fly follow all waypoints without transmitter?

Once you start, it will follow each waypoint without any control from you.

Gerry1124 Posted at 2014-12-2 10:07
Once you start, it will follow each waypoint without any control from you.

Thank you so much. My English was not good and Big thanks for your help.

phisit2738@gmai Posted at 2014-12-2 10:09
Thank you so much. My English was not good and Big thanks for your help.

My question is

[I want to know about
1. When I use waypoint - mode and then I switch off my transmitter or signal lost How do Phantom+2 work after that?
2. When my Phantom arrived each Waypoints, Can I control it to spin for take a photo around my waypoints? ]

I am confused. I asked this question in https://www.facebook.com/DJIglobal but they told me that...
1) Your Phantom 2 Vision+ should return to where is took off. This is called "Return to Home"
2) Yes, the pilot must control the Phantom with the controller even with waypoints planned

phisit2738@gmai Posted at 2014-12-2 11:48
My question is

[I want to know about

I've already answered that.

Thank you for your confirm.

WHEN I TURN MY PHANTOM 2 AND TRANSMITTER ALL WOKS FINE.. AND CONECTED,  BUT AFTER A FEW SECONDS THE SIGNAL LOST AND ENTER ON FAIL SAFE MODE.. EVEN IF I CLOSE (1 METER) AND WITHOUT ANY INTERFERANCE.. I DO ALL ITS POSIBLE AND NOTHING WORKS. THANKS FOR YOUR HELP.

SORRY FOR THIS COMENTS.. BUT I CANT OPEN A NEW TREAD.. I APRECIATE ALL COMENTS TO HELP ME..