Folks,
I have a FoxTech RHEA160 rig with an A3 flight controller and Lightbridge 2 RC.

When I start up the unit I get a blinking green with no problem. However, from the moment the UAV moves laterally, I would get a solid red error.


I first noticed this error while doing a programmed flight. Even though the error was there throughout the flight, the unit flew without any problems and landed as normal.

This error is easily replicated by turning on the UAV and manually lifting it off the ground after it has initialized.

Any help would be most appreciated.

Folks,
I have a FoxTech RHEA160 rig with an A3 flight controller and Lightbridge 2 RC.

When I start up the unit I get a blinking green with no problem. However, from the moment the UAV moves laterally, I would get a solid red error.


I first noticed this error while doing a programmed flight. Even though the error was there throughout the flight, the unit flew without any problems and landed as normal.

This error is easily replicated by turning on the UAV and manually lifting it off the ground after it has initialized.

Any help would be most appreciated.