Hey Everyone,

Having issues getting the OSD to work with my O3 and Nazgul Evoque v2 in Betaflight.  I got the OSD to work somehow through the ports and CLI section but had to reflash from the Iflight preset and lost my progress.  I'm having trouble figuring out the correct UART number.  

Also,  I am getting terrible range.  When the unit starts up I get 50Mbps and then immediately drops to 7mbps.  Assuming this has to do with the wrong MSP turned on in the ports section.  I'm pretty new to FPV,  any help would be appreciated.  


Thanks


UPDATE : Disregard,  figured it out with the help of this video.  

I just did the same on my Sector 5D but with a vista. I found this helpful:

Iflight board is msp serial -1 in beta flight or try 0, also check your aerial connections are correct if you have two female sma's you will get instant loss of signal. If your getting 50Mbs once armed then you have the correct msp port enabled, msp port for the dji 03, with the 20x20 iflight is msp port no.1