I hadn't flown my FPV in a while, but I fired it up a couple of days ago. I was seeing some strange symptoms inflight, accompanied at the end of the flights with "Sensor System Error".


I hooked it up to DJI Fly, and did all of the updates that were available for the various system compenents.


But when I then went to go fly, I got alternating error messages in the goggles:


"IMU Initialization Error"
"Sesnor System Error"


What can I do about this? I didn't see anything about it in the manual, with a quick check.


Suggestions appreciated!


Thx


TCS

Hi, Chaosrider. Thank you for reaching out. Please try the steps below to isolate the issue:
1. Restart the Goggles, the aircraft, and the remote controller.
2. Please connect the devices to DJI Assistant 2 and refresh the aircraft firmware. You may download it from this link: (https://www.dji.com/downloads/products/dji-fpv).

Please keep us posted. Thank you.