LV_Forestry
First Officer
Flight distance : 4726654 ft
Latvia
Offline
|
cpillotongmail.com Posted at 6-8 12:09
I have confirmation from the NC CORS network administrator from their logs that I was logged in and they were sending back correction data. This confirms that I was connected via wifi, had the correct parameters entered and was transmitting.
Status message on RC was "Connected. Converging data". Tried different locations (one within 2.5 km of physical CORS station) at ground and 200' AGL, different mount points, etc. etc. etc. Never got past converging, did briefly get some correction data but it never went to FIX status.
Very frustrating - you should feel lucky if it's working for you!
Have you tried to deactivate the RTK, take off, reactivate in flight? Because on the ground it's sometimes very hard to have a FIX, a building, a tree... and it stays in converging state.
Then there is the format of the corrections that your provider sends you. You have to make sure that it sends the information corresponding to the requirements of your receiver.
NC CORS is a Trimble network so in principle there should be no problem. |
|