We had a incident with our P3P user error landed in some water. Got it all taken apart and put in rice for 3 days. Took it out and booted it up and gimbal GPS, Camera all worked but each ESC is burnt on the main board. Just got a new board in today and wondering if I need to do anything other then just swap out boards and plug in wires?

Thanks

You will need to solder on the motors,LED's and the battery power cables..

The after confirming it powers on and things seem ok, make sure to do a firmware update and calibrations..

Good luck.. If you can document the install that would help others

Awesome! I already unsoldered the old motors/LEDS but Ill document the swap and install!

raiedzeidan@gma Posted at 2015-8-27 22:31
Awesome! I already unsoldered the old motors/LEDS but Ill document the swap and install!

Hey, did you have any issues with the main board replacement?  I just replaced mine and cannot get the initial start-up beeping to stop.  All connections seem to be good, the LEDs work fine, but the motors wont turn and the beeping won't stop.  Just wondering if you had any of the same experience.

ESC error message?  If so, ensure the solder connections are solid.