Hello Everyone I am new to the DJI world, I purchased my Mini 3 Pro in January, but I haven't used it much in the winter! Now that I am starting to use it more, I am not happy with the video! The video seems to kidder and flicker. ! I have it set in normal mode, MP4 format, colour set to Normal, Coding Format = H264, and Anti-Flicker = Auto. Is there a way  to get a more stabable video? The following is a link to a example of a video. You can see a wave in the video.

https://youtu.be/YMNgdNsuw6Q

Here it is with preview

This is not normal.
Try calibrating your drone and check the props if that does not work.
(maybe replace them all, and see if it goes away)

Hi there. Thank you for reaching out and we're deeply sorry for the trouble. Can you please try to perform the IMU and Gimbal calibration to see if the issue persists? In addition, did the unit experience a hard landing before? Please keep us posted. Thank you.

This problem start almost since I purchased the drone. I had a couple videos that were ok and then the problem started. There was no hard landing. I have performed all calibration and changed all propellers. And the problem consisted. I remover the lens cover and the problem got worries!

Held4Ransom Posted at 7-3 16:13
This problem start almost since I purchased the drone. I had a couple videos that were ok and then the problem started. There was no hard landing. I have performed all calibration and changed all propellers. And the problem consisted. I remover the lens cover and the problem got worries!

If the drone ever crashed or experiences any collision, we recommend sending the drone for diagnosis. If not, can you please follow  the steps below:
1. Kindly remove the gimbal protector before powering on the aircraft to prevent the gimbal motor from being stuck, or the gimbal will become shaky.
2. Please make sure that the gimbal is in Follow mode. If it is set to FPV mode, the gimbal view will be tilted when the aircraft tilts.
3. Please check whether the aircraft is in Sports mode (S-mode) when the gimbal becomes shaky. In S-mode, greater emphasis is placed on flight performance. During flight, when the aircraft attitude is too large, the gimbal attitude stabilization cannot be guaranteed. If the gimbal is shaky in S-mode only, which is normal, please switch the flight mode of the aircraft to Normal mode (N-mode) or Cine mode (C-mode) to achieve a more stable view.
4. Please check whether the wind was strong in the flight environment. If the wind is too strong, the aircraft will vibrate, resulting in the image transmission screen being shaky. We recommend that you test the gimbal in a windless or breezy environment.
5. Have you ever adjusted the EXP value of the aircraft? EXP refers to the drone's exponential. The higher the EXP value, the higher the aircraft response sensitivity, indicating that the aircraft will respond flexibly to small stick movement. If you have ever adjusted the EXP value, please go to [Control -> Gain & Expo Tuning] in the app, reset the parameters, and then test the aircraft again.
6. Please perform gimbal calibration in the app. Using with DJI Fly: [Settings -> Control -> Gimbal Calibration].
If the steps above was done and the issue still persists, we advise submitting an Online Repair Request and sending the aircraft back to DJI for further diagnosis.