jamesnns
lvl.3
United States
Offline
|
Here's the way Iv repaired stripped threads in the past when getting a new part was expensive...
Take your P2 to the hardware store (only if you dont know the exact threading of the spindle) and match up a stainless steel nut to a spindle that isnt stripped. Buy 4 nuts. Get home, put nut in ratchet set that matches nut, put nut on stripped spindle, turn 1/8th to 1/4 turn while holding motor stable with wrench. Back off nut each turn Repeat until rethreaded.
it does take some time, but an easy try before you go replacing a motor just cause a spindle is stripped.
Or i suppose you could bring a prop, match up a bolt, then find the nut that way.....prob easier
|
|