I have repaired my Vision plus gimbal with a new ribboncable. Unfortunatly the gimbal/camera does not work. The gimbal LED stays red/orange, it does not get green.
Any sugestions on why?
The gimbal does not show up when i connect the phantom to the computer via the assistant.

thx for at great forum

It's either the one of the three plugs that go to the gimbal, a pin loose in one of those plugs or it's still the ribbon cable  with one of the clips not making good contact.

roy@mcscomputer Posted at 2015-11-3 11:37
It's either the one of the three plugs that go to the gimbal, a pin loose in one of those plugs or i ...

Thank you for your reply.
That could very well be the problem the plugs are very worn, so i might have to change the cables.
Today I notised that the gimbal motors get hot, but the gimbal does not move at all. Could i be the motor that is TOAST?