sam
lvl.1
Australia
Offline
|
Hi guys,
I'm after some direction to help me assemble my s900. mostly I am trying to get the controllers setup for dual control, but after a couple of days of scratching my head confused, I thought some-one might be able to give me some direction, if they have come up against the same problems: or they just know!!
I'll add some extra detail, incase I'm missing something.
I've got a s900 and lightbridge, A2 flight controller and z15 bmpcc gimbal with a Futaba T14sg controller (with futaba R7008SB 8ch + S.Bus receiver), I also have a 5.8 ghz Phantom remote controller. The s900 is built, and wired accordingly to manuals/videos. I also have the software installed on my mac, and I have managed to update all components, except the GCU for the gimbal- for some reason (or I'm not looking in the right place) it doesn't come-up. I have the GCU directly into my computer via USB.
So, what I need help with is getting the remote controllers talking to both the s900, and the gimbal. I've checked out various web videos, forums and manuals, and I feel that i am in an area not too well covered.
For, the gimbal, this is what I have done (but it might not be right)- i watched a DJI video. I connected the DJI phantom remote receiver to the Aux2 plug on the GCU, and I tried to pair the controller to it. I think it is paired, the remote has a steady green, and the led on the receiver goes out when it is on. I did this after the gimbal went through its initiation. But I still cannot get any control on the gimbal.
When I go into the DJI A2 assistant software, and I go to Advanced>Gimbal, i turned the gimbal on in the software, but when I go to the wiring tab (bottom right), the program freezes- but maybe this is because something isn't quite right?
Again, maybe this is not the best way, or I am missing a simple thing, or should I be going through the A2 flight controller or light bridge??
I also want to try and get the futaba remote going to control the s900, is the best way to go directly through lightbridge, or do I need to use the futaba receiver...
Sorry for the huge message, but I thought the more detail the better. Any help would be very, very much appreciated!!
What do I do!!
Sam
|
|