I have a new Phantom 3 Advanced that arrived yesterday.  Charged all the batteries and started updating the firmware to 1.6.  The Phantom updated fine but the Controller doesn't do anything.  I've plugged in the micro SD card in via a reader and nothing.  I inserted the card into the Phantom and plugged the RC into that.  Nothing.  The RC just sits there powered up.  It won't ininitiate the update.  I've tried many times.  Help?  Thanks,  Neil

There was no remote update in 1.6. only in 1.5

wsaund Posted at 2016-1-7 08:26
There was no remote update in 1.6. only in 1.5

Instructions say to update to the latest firmware so I did.  There is no info on the site saying to update the controller to 1.5.  So do I update the controller to 1.5 and leave the phantom at 1.6?  Thanks.

nbosdet Posted at 2016-1-7 08:40
Instructions say to update to the latest firmware so I did.  There is no info on the site saying t ...

I tried to update the RC to 1.5.  Same problem.  It won't initiate.

Please check the "Overall Status" in your DJI Go App . There would be a reminder if your RC needs to be updated . And your RC is updated via DJI Go App .