Hello,

Having issue with the firmware. I have updated and i read the output file on the disk that it installed successfully but, I am still receiving when I boot up that the battery and the aircraft needs to be updated. I did the sd card load and I got a success output file. I tried sync the controller directly to the aircraft, successfully.. Still getting same error. What am I doing wrong?

I boot up everytime adn it keeps telling me this! I reinstall the app and I am having no luck!

Ideas?

In the go app you can see what version is loaded in the aircraft and battery so you can see if its the newest.  If its not, make sure you have deleted the txt file from the sd card before updating.  Also make sure the newest version is on the sd card.

I also saw in another post where DJI recommended someone to uninstall the GO app and reinstall if you do have he right firmware.

Ok, I did that and the App is at 2.5
Controller is 1.5.70
Aircraft is 1.4.10+

Is this correct?

BRW2339 Posted at 2016-1-17 14:59
Ok, I did that and the App is at 2.5
Controller is 1.5.70
Aircraft is 1.4.10+

The latest aircraft is 1.6 something