I'm wondering if there is a way to reset the IOSD Mini if the software is up to date?!

I crashed my Phantom II with a faulty battery. First everything worked - shortly after I got scrolling and dizzy screen on my Black Pearl.
I got a new FPV Cable hub which did not change anything.
Next a new AVL58 did not change anything.
Than a new IOSD seems to solve the problem.
But when I plugged in the H3-3D gimbal - the problem was back :-(  I noticed a broken cable on the gimbal ... replaced the cable but even without the gimbal the screen is scrolling.
So I'm wondering if I can test or "reset" the IOSD ?!

Any help/idea would be great!

Hello, it would be better to post a video of this issue here

DJI-Paladin Posted at 2016-4-5 18:37
Hello, it would be better to post a video of this issue here

Hi:
please see the video of the issue at
Thanks

Paw Posted at 2016-4-5 19:42
Hi:
please see the video of the issue at
Thanks

Hello, have you tried to remove your iosd mini from the FPV hub and then tested the FPV hub with AVL58 separately? And you can also switch NTSC to PAL on your monitor to give it a try

DJI-Paladin Posted at 2016-4-6 09:30
Hello, have you tried to remove your iosd mini from the FPV hub and then tested the FPV hub with AV ...

Hi - thanks for the reply.
Without the IOSD plugged in I have a black screen even the video is recording.

When all is plugged in the video is "rolling" in the back (a bit scrambled in black and white) ... but it shows. Just FYI - I did change the video output connection cable on the H3-3D twice - to make sure it does not cause an issue.

Paw Posted at 2016-4-6 20:13
Hi - thanks for the reply.
Without the IOSD plugged in I have a black screen even the video is rec ...

Have you tried to switch it to VID mode on the FPV hub without IOSD?  Does the changes of PAL/NTSC work?