This week I have been flying my P3P from the back of a boat. Several times I would try to take off, I would get an error saying the gyroscope bias was too large and I needed to restrart the aircraft. Was this error caused by the rocking of the boat?

Hello, I'd suggest you to calibrate the IMU :

But now this option's location has changed to MC settings_Advanced Settings_Sensors_IMU Calibration

DJI-Paladin Posted at 2016-4-8 02:10
Hello, I'd suggest you to calibrate the IMU :
https://www.youtube.com/watch?v=4WGZUl5n1fA&list=PL8-v ...

I will do this, but do you think the drone sitting on the moving boat while it was starting up had anything to do with it?

Thanks!

ccbiggz Posted at 2016-4-8 17:54
I will do this, but do you think the drone sitting on the moving boat while it was starting up had ...

I'm not so sure about this but normally it couldn't.

ccbiggz Posted at 2016-4-8 17:54
I will do this, but do you think the drone sitting on the moving boat while it was starting up had ...

I've also had this problem and every time I needed to restart the aircraft and also take off battery. I solved with a IMU calibration.

Do you have this problem also when you start your aircraft on a fixed surface?

Nicola90s Posted at 2016-4-8 07:56
I've also had this problem and every time I needed to restart the aircraft and also take off batte ...

Yesterday was the first time I had a chance to fly it. I was planning on doing the calibration, but when I turned everything on it didn't give me that error. I took off and flew around normally. I'm still going to go through the calibration though.

Thanks!