walterm
lvl.1
United States
Offline
|
For firmware at or below 1.2....
place the firmware on an empty usb drive. make sure that is the only file on the drive. place in the usb slot on the remote. turn on remote. after about 60 seconds the status light should go blue and the remote will start beeping. when it stops the status should go green. your done.
For firmware at or above 1.3
connect your phone/device to the remote, turn both on and goto the dji app. press the remote controller icon. should say update required. press on this and the dji app should download and install the firmware. same blue light and beeping from the first step. hope this helps |
|