Anyone have the same problem after updating the P3S to 1.6.80?  I can control the camera and gimball when I use the left/right sticks on my controller, but i cant start the motors.

The DJI App verison is 2.8.3

Aircraft Version is 1.6.80the application reports the error "RC Signal Lost"

Aircraft displays a slow blinking yellow light

DJI App shows zero bars for sattelites and  reads Safe to fly in non-GPS mode when I have the RC set to P-ATTI.

Any help would be appreciated

========== 2014.01.01 00:00:15 remo-con disconnect======
Packet: P3C_FW_V01.00.0020.bin
Upgrading ...
Result: Success.

========== 2016.01.12 22:45:37 =====================
Packet: P3C_FW_V99.99.9999.bin
Upgrading ...
Result: Success.

========== 2016.06.16 19:57:22 =====================
Packet: P3C_FW_V99.99.9999.bin
Upgrading ...
Result: Success.

Hello chrisbryson7374, please try to relink the RC and drone. When it finishes linking, don't turn it off immediately and wait for 5 minutes. Then reboot the drone and try it again in open area.

I have had the same problem yesterday resolved by restarting everything in order of transmitter - phantom - wifi connection - go app. worked fine after though i still encounter lost video feed randomly and rth because of the known p3s firmware issues that are being addressed in the next update.