Hello everyone,

I managed to break off my S1 3-way toggle in December when I put down the controller on a rock and it slid off.

I have been trying to find an original replacement part that I could solder in as a replacement. My authorized dealer hasn't been much help, and I can't see anything like this on the DJI store. Has anyone had any luck tracking one down?

thanks,

dave

Not OEM but these should work.

http://www.ebay.com/itm/Lot-of-2 ... hash=item27d5a5e426

JATO Posted at 2015-1-24 08:55
Not OEM but these should work.

http://www.ebay.com/itm/Lot-of-2-3-Way-AC125V-6A-Mini-Toggle-Switch ...

I was hoping to get an oem version so that it matched to S2 toggle. I'd like to sell my old controller (got a Ver3 one with the gimbal dial - nice!) and it would be nice if it didn't look all disfigured... maybe replace both with a pair of these?

Got them on EBAY

http://www.ebay.com/itm/THREE-PO ... hash=item5b0b49d240

Gerry1124 Posted at 2015-1-24 09:25
Got them on EBAY

http://www.ebay.com/itm/THREE-POSITION-TRANSMITTER-TOGGLE-S1-S2-MODE-SWITCH-FOR-US ...

thanks for the link. Wow, with the shipping, these ones are about 5x more expensive, and it's only for 1 toggle. Maybe I will get the pair in JATO's link and replace both - it's <$5.

DiscoDave Posted at 2015-1-24 09:35
thanks for the link. Wow, with the shipping, these ones are about 5x more expensive, and it's only ...

As long as they are 3 position switch, they will work.

Gerry1124 Posted at 2015-1-24 09:38
As long as they are 3 position switch, they will work.

Thanks for your help Gerry!

DiscoDave Posted at 2015-1-24 09:41
Thanks for your help Gerry!

Happy flying.

I also broke my switch, but I cannot get it out of the controller. Could you help me out? I tried twisting and pulling but it's stuck in the controller.

You need to unscrew the threaded ring that holds the switch in the controller. I use needle nose pliers to loosen the the ring.