Hello and thanks for the help in advance!

I am trying to set up a Naza v2 FC. A few weeks ago I had it connected to the computer and functioning as expected but had issues with my tx/rx I had to resolve. Now that I have connected a functioning tx/rx to the Naza, I can't seem to get it to do anything other than flash "4x rapidly blinking red led" .... it won't connect to the computer (LED turns green, never yellow, and won't connect to the Naza application). I have tried two different tx/rx combos with the same result. I have looked up what the flashing means (tx mid-point settings to high) but cannot change that if I cannot connect to the PC.

Anyone have any ideas?!

To clarify, what operating system are you using? Do you get an audio queue from your computer indicating that something was plugged in? What kind of RC/Receiver combo are you using? Could you perhaps provide a small video on now you're attempting to connect to the Naza Assistant Software?