I bought a p3s about 2 weeks ago all was good until i had a rough landing where the the drone rolled over no visible damage was done. For a few days after everything was working ok until i tried to fly it and noticed the camera was tilted diagnally. I havent flown since and the gimbal is making a very loud buzzing noise. I do not no what to do. In both pictures the p3 was hovering not moving. I have recieved gimbal motor overload error before.

this is a link to what it looked like when tilted- http://imgur.com/a/YZPxz

this was before it was tilted- http://imgur.com/a/TKwBa

Hello connoryankees4, did you try to do the gimbal calibration?

DJI Mindy Posted at 2016-8-29 23:58
Hello connoryankees4, did you try to do the gimbal calibration?

yes i have tried that but it is still tilted

connoryankees4 Posted at 2016-8-30 23:30
yes i have tried that but it is still tilted

It's probably a hardware issue.I'd suggest to email support.us@dji.com,tech support will help you out.

DJI Mindy Posted at 2016-8-30 21:42
It's probably a hardware issue.I'd suggest to email ,tech support will help you out.

DJI Mindy


u certainly r good for after sales service.... very , always helpful

Now, I want to purchase a Litchi mapping system for my perfectly performing P3S.... is Litchi the best for my bird ?

daddiosbarbersh Posted at 2016-8-31 21:59
DJI Mindy

I'm not familiar with the Litchi.I'd suggest you use the DJI GO app.

DJI Mindy Posted at 2016-8-31 20:32
I'm not familiar with the Litchi.I'd suggest you use the DJI GO app.

There is a YouTube video showing you how to repair your camera gimbal.  When you crashed you misaligned the shaft on the camera housing. There is a setting where you can correct a misalignment if it is not too drastic. If however the shaft has been loosened and twisted in its housing you can realign it and lock it back  in place with a little locktite or epoxy. Search for the videos in YouTube and there are a couple that will help you.