Please select Into the mobile phone version | Continue to access the computer ver.
Motor support beam
779 0 2015-2-4
Uploading and Loding Picture ...(0/1)
o(^-^)o
craigarthurson.
lvl.2

Australia
Offline

I know there was a post was trying to find it but not much luck.
Just got my inspire 2 days ago taking my time in getting ready to fly all weekend prop locks here all good.
I was going over the inspire and found a level of play in the horizontal motor support tube between the T bar and the large hex head like jam nuts.
Now the flay allows the the motor support tube to move approximately 2.5 to 3 mm at foot of the motor and at the jam nut approximately 0.75 mm.
Is this normal I know it has to have some play to alow the gear to move with out any binding.
I await some feedback
2015-2-4
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules