Updated after flying now will not start up

Fans492b5fcc

Have you tried downgrading and reapplying the firmware update? Just to clarify, what firmware are you currently on and what were you on before?

I had ver 1.10. 90  now trying to put back on the text old or same ver when I read the chip

fans492b5fcc Posted at 2016-12-30 02:10
I had ver 1.10. 90  now trying to put back on the text old or same ver when I read the chip

You have an advanced or professional aircraft?
Would you please format the SD card and try to upgrade it again?
Also you can restart the aircraft for several times then check again.
What mobile device you are using? APP is up to date as well?

Using advance
Upto date on rc will I lose pics if I do the SD card

Using dji go and tap 7 A samsung

Whenwillbehappy Posted at 2016-12-30 02:50
Using advance
Upto date on rc will I lose pics if I do the SD card

Please copy the pictures or videos from the SD card to your PC before you format it.
Have you tried to delete the DJI GO APP and re-install it?

Try calibrating the RC.

Don't know how to get screen shot on here

Yes I have reset the control and reinstall ver 1 10.9
The tab that been having problems with also when I did update but dji says everything else
So just trying to figure out
The lights Blick green camera light green everything good until I try to start motors then puts  error up will not start motors

Not sure how  to load last flight on

I'm looking for help on this also. I have experienced the same exact problem after updating the firmware on my P3P. Using an Ipad 2 Mini DJI Go app and RC or updated.