I downloaded the latest firmware to my P3A and check the file and it said successful, then I checked the staus and it was normal. I turned it off for a while and when I turned it back on it said I needed to update firmware. Do I need to go through the whole thing again or can I just put the sd card back in, the file is still on the card? I didn't have the card in when I turned it on the second time. Is it safe to try and fly?       Thanks for any help

Do you know what fw version you upgraded from?

There was a battery upgrade between 1.8.80 and 1.9.60. If you upgraded from 1.8.80 to 1.10.90, then you should leave the fw on the sd cad and insert each of your batteries into the P3 and upgrade each one. It will only take a few minutes. If this is the case, the battery will flash the center two leds as the firmware is loaded and upgraded on the battery.

But, if you upgraded from 1.9.60 to 1.10,90 and it was successful as you indicate, then it should not be prompting you again. We'll need to investigate the upgrade log files further.

The drone is brand new and I downloaded the 1.10 90 version.

Ok , I just checked and it says I have the latest firmware.   Thanks