Hello, the latest upgrade for the phantom 4 has a large problem in the picture that transmits on tablet. The picture is lost per 2 seconds and shows up only black.
Can someone help me to solve this problem?
Thanks.

Have a look at my post HERE, also have a read of all that thread, and my comments in post number 10.

Aardvark Posted at 2017-3-1 02:52
Have a look at my post HERE, also have a read of all that thread, and my comments in post number 10.

Hi,
I did downgrade not to 1.6 but to 1.5 by mistake (for p3) . Νow the controller and phantom4 it is not communicate. The controller It seems to be p3 in DJI GO and does not accept the upgrade to 1.6 or 1.8. What can I do?
Thanks

nikos8 Posted at 2017-3-1 06:19
Hi,
I did downgrade not to 1.6 but to 1.5 by mistake (for p3) . Νow the controller and phantom4 it is not communicate. The controller It seems to be p3 in DJI GO and does not accept the upgrade to 1.6 or 1.8. What can I do?
Thanks

Firstly try 'resetting & relinking' RC & Aircraft'. This 'pairs' the RC to Aircraft.

Try to reset the RC:

* Turn on the controller, and the aircraft should be off.
* Press C1, C2, and shutter (top right button nearest antenna) on the controller and hold until it beeps, then turn the controller off.
* Turn on both the aircraft and the controller and link the remote.

I would recommend manually relinking the RC by performing the following;

* Turn on both the aircraft and the controller.
* Press C1, C2, and the record button (top left button) on the controller, then the controller will beep like D-DD.
*Let go all fingers, press the wheel on the right side of the controller and then the first light of the controller will become blue and it will constantly beep DDDD.
* Use a pen to click the linking button on the aircraft and hold for 3-5 seconds, and then take the pen off the aircraft and wait, it will be linked soon.

nikos8 Posted at 2017-3-1 06:19
Hi,
I did downgrade not to 1.6 but to 1.5 by mistake (for p3) . Νow the controller and phantom4 it is not communicate. The controller It seems to be p3 in DJI GO and does not accept the upgrade to 1.6 or 1.8. What can I do?
Thanks

Note that the right hand wheel on the RC does 'click' like roller wheel on a mouse.

Hi
I press the buttons and do not make a sound..

nikos8 Posted at 2017-3-1 07:47
Hi
I press the buttons and do not make a sound..

Hold them all operated together for about 3-5 seconds you should get a bleep.

Aardvark, Thank you very mach!!I
Finally not unblock the controller with the pressure on buttons. But I managed and did the upgrade to 1.60 firmware, and now works excellently !!

Thanks!