fansa6e27bfd
 lvl.2
United States
Offline
|
I just had this happen to me today. Brand new bird, going on 2 days old. Unboxed yesterday, upgraded to latest firmware. Took it for some test flights. Focus was spot on intially (in default profile/color profile), changed to d-log, changed customer setting, tried to focus, drone indicated it was in focus but wasn't. Flew several passes trying to make sure it was properly focused (c1 - center focus and tap). Everytime mavic registered that it was in focus but I could tell on the phone screen it was not. Brought the bird in and went out in the evening to retest it. From get go, issue was still there. Made a couple passes trying to focus, no help. I did a camera reset mid flight and boom, camera was in complete focus. After reset it went into 4:3 photographic mode, peaking enabled, seemed to be default profile. I changed to video mode and "peaking" was still enabled. Recorded with everything default and everything was in focus. Mid flight I change to d-log and customer settings and shortly after the focus starts to have issues. I got home and downgraded the rev the previous rev. Took it out for flight this morning to continue testing. Off the bat, focus was poor, tap focus/c1 no good even though mavic registered it was focused. Continued to fly and front sensors start complaining due to the sun. I disabled all sensors and continue. About 3 minutes later, the controller starts beeping like made like its detected something (like sensors still enabled but they were not). It was just continuously beeping even though obstacle avoidance was turned off. I stop mid air to hover and noise stops. I continue my flight and boom, this happens, camera freaks out, I lose control of the gimbal, looks like the mavic is starting to fall out of the sky from the video feed but I soon realized it was because the camera/gimbal is doing something odd like a reset/gimbal startup. Lose the gimbal for about the same time it takes to initialize the gimbal. When it recovers, all my settings have been changed. I've lost dlog, camera went from what I had iso100 to iso3200, camera out of focus, profile was set to none. I realize the camera/gimbal had reset itself mid flight. Not fun at all. Bring the bird back in.... now contemplating what to do. It almost seems like a short somewhere. I wasn't in sports mode but did have the throttle pinned to the edge of the stick range. I didn't get any errors though. This is my 4th bird, 1st 2 had focusing issue, 3rd one has violent gimbal initialization and then would constantly give gimbal overload error but other than that it has been fine. 4th one I thought was having focusing issue but seems to be turning into something else now with this whole camera/gimbal reset midflight. Definitely scared to take it up again. The QC has been terrible with the mavics. |
|