Hi,

the DJI GO App says the front vision sensors apparently are not working properly. As a result I can't use any automatic modes. Calibration via DJI GO App fails (don't know why).

So I tried the calibration via the DJI Assistant on my PC. I can run the calibration process perfectly but during collecting data information the calibration stops at 85% no matter what. Tried it three times now.
I read in other threads about this problem, but got no solution to it.

Got the latest firmware installed (both for the Mavic and the DJI Assistant 2) and my device manager tells me that drivers are working just fine (Windows 10).
(And there is no foil on the sensors either.)

Don't know what to do. Please help, it's kind of annoying and time consuming...

Thanks in advance.

Hello Bender, please try to reset factory defaults and refresh the latest firmware then do the calibration again.
If you still fail to do the calibration, please post some screenshots for better assistance.
Besides, do you have another computer to test with?