Hello guys
in my monitor i dont get the distance reading from home point ... I get only height.
Can you suggest where is the problem?
My s1000 finds home all the time and have take off after that ......

Make sure its up to date,

It is .... I don't get any new version.....

Just checked ... There is no new version for update .
After locking 15 - 16 satellites and have a take-off  i get like the attached image.The height is correct but i get empty reading in D ( in my monitor).....
Any thoughts?

Regards

Any ideas please?????

mini iosd or MarkII?

Blade_Strike Posted at 2014-10-16 04:17
mini iosd or MarkII?

Mark ii ......

IMHO something is not updated. Please post screen shots of both assistants upgrade screen.

Ok I will.....

Here we are.....

????????????????????????????

Any ideas?

ναι καλά...και άμα βρεις άκρη από αυτούς εδώ γράψε μου ... μάλλον πιο εύκολα θα το βρεις μόνος σου
Εδώ ρε συ πόσο καιρό τους κράζει όλος ο κόσμος για την παπαριά που έκαναν με την αναβάθμιση του H3-2D και δεν ιδρώνει το αυτί τους...
Να μην αναφέρω και αυτό το έρμο το support που σε παραπέμπουν κάθε τόσο και δεν απαντάει κανείς τους :@

nikolaospaschal Posted at 2014-10-16 15:28
Mark ii ......

If your on the latest version of the iOSD FW 3.02, you should have an Azimuth reading as well, should be Distance, Height, Azimuth. It doesn't appear on the screen you provided.
I agree with Blade, you need to update it and also, tell us what flight controller you have it connected to. If you are using the A2, are you connected to the right bus?

High!
I have the same problem with the iOSD Mini.
Assi-software  4.0
Firmware: 1.06
It shows the height, satellites and so on, but now information about horizontal position.
No direction to home point, no distance, no horizontal speed.
So, DJI, and please dont suggest to make an update.
What can I do?
Fishermen