Hi, I saw a few posts about this but wanted to check again.



My x5s has some dust behind the glass that protects the sensor and also inside the lens.. DJI has quoted me $1000 AUD to replace the lens and $1800 AUD to replace he camera holder module. This is the essentially the same price as a new x5s, lens and gimbal. I find this ridiculous that they can't take the camera apart and clean it much like any other camera. It should cost a fraction of this. The drone wasnt flown anywhere excessively dusty but either way, dust on getting on sensors is common and there should be a simple cost effective way to fix this



Has anybody else had this issue and did they clean the dust out?


Pics below


Thanks!

They look like big lumps of dirt (Dust 2).  

I think that if they sealed inside  the glass protection filter they should do it for nothing - it's dirt that's been in there since manufacture, surely?  
The lens could probably be cleaned out very easily by a lens repair company for less than £150.  

Bad luck anyway.