djiuser_jSuLujtRtFLU
New
Algeria
Offline
|
Hey i got an issue with my own ronin m that i bought from someone and. And he said that sometimes the gimbal starts spinning and yesterday it has stopped working properly, i have checked the part cable no 33 and the white wire was cut somewhere in the T part, I have no warranty and i live in algeria and there is no dji service repair shops or anywhere that i can fix it, so i have tried the zip ties on the T part and didn’t work than i stepped to do the repair for my self, i have cut the 3 cables that comes out of the T soldered a new cables, did check that they are not shorted or cut somewhere else, but did not work, after that i connected to my computer, Turned on motor kill switch after turning it on the g sensor was working, the motors position works on the live diagram, any idea or anything that i can do by myself to do cause i think its a software issue, could anyone help please ? |
|