wayne.wayneaust
lvl.2
Flight distance : 862280 ft
United Kingdom
Offline
|
OK, So first post on the forum and I wish it could have been a postive experience, sadly, it's not.
Had my P3 Pro for some time now and done numorous Firmware Upgrades without issue, until today.
Went through the steps to upgrade the FW on the phantom, all ok there, then the RC via the app all seemed to go fine, the app asked me to switch off the RC and turn back on, this is where it went wrong. Upon turning on I didn't get the ususal beep on the RC, and the First light was a Cyan colour, the remote is saying that the FW is up to date but it will not connect to the P3 so I did some investigation work.
1) Tried to re-pair with the P3, nope
2) Found a thread on how to force an upgrade, failed (I have the GL300B Remote) Attached are some screen shots: *RC is 100% Charged
The app downloads the new FW and then attempts to install it and then just fails, no blue flashy lights or anything. Looking into the logs on my phone reveals this:
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
upgrade faileddevice[OSD]err[NOCONNECT]reason[Enter Loader Mode failed]
So far I have been trying to fix this for the last few hours and sad to say I have a brick, the remote is still connecting to the phone albeit saying "No Signal" but as far as anything else it's dead.
Any Advice or is it an RMA Situation ?
|
|