betonven
lvl.2
United States
Offline
|
So...
the good news: The horizon issue is FIXED. I mean, almost, it will still slightly miss the horizon after a turn, but it will slowly get there by itself, within half a minute or so, without needing you to adjust the dial for ever. That's acceptable for me and my use.
the bad news: After I installed the firmware, I started having the gimbal vibrations again when I tilt the bird to the left. The vibration starts in an intermediate position (about 10-15 degrees), stops after, and continues at a steep angle (where it becomes horrible).
Now I don't know if this was caused by the firmware or just randomly. What I noticed though is that during the cold IMU calibration I did after the firmware install, the gimbal was acting crazy, making HORRIBLE noises and shaking, as it was struggling to work in conditions it shouldn't. I'm not sure if this somehow caused the vibration I started noticing after, but I really cannot understand the reason DJI cannot just deactivate the gimbal during IMU and compass calibrations.
Now I really don't know what I should do. I want to keep it, I don't think it causes me some footage problems, but the for some reason reduced 6 months gimbal warranty makes me just not trust a piece that has started already behaving erratically only after 2-3 flights and costs more than 500$ to replace.
Any piece of advice? |
|