Loss of F-Mode functions
Uploading and Loding Picture ...(0/1)
o(^-^)o
DJIAndy
lvl.1
Australia
Offline

My DJI Std 3  lost the function modes after an update, no matter what I do or where I look I can't access them (10m up and 10m away), (Multifunction mode is on).  I have been flying it for over a year. With no problems before this.  Current verison of software is 3.6.1  any suggestions?

2017-6-26
Use props
Labroides
Core User of DJI
Flight distance : 9991457 ft
  • >>>
Australia
Offline

You'll have to enable multiple flight modes again.
It's one of the settings that reverts back to default settings on updating.
2017-6-26
Use props
DJI Diana
Administrator
Flight distance : 2408 ft

Offline

Andy, make sure the Beigner mode is disabled, then switch the S1 to the bottom, see if you can get into the F-mode. If it is the same, please post a short video about this issue for better assistance, thank you in advance.
2017-6-27
Use props
RicardoGray
Second Officer
Flight distance : 4356421 ft
United States
Offline

I believe there were instructions stating that with the new upgrade, if may turn some functions back t o the default settings, and that you should re-check everything in your app before flying. You may have multiple flight turned off.
2017-6-27
Use props
DJIAndy
lvl.1
Australia
Offline

Thank you everyone for your quick replies.  I had checked and done all the things you suggested, but I could not find the functions, turns out I had to authorise the use of them when touching the controller button on the screen.  It would have been less confusing had the app asked me to authorise that when I was changing the multifunction setting.
2017-6-27
Use props
DJIAndy
lvl.1
Australia
Offline

Problem fixed, see my comment below.
2017-6-27
Use props
Advanced
You need to log in before you can reply Login | Register now

Credit Rules