GONLADAR
lvl.1
Flight distance : 14705 ft
United States
Offline
|
I have been battling with all of this for weeks! I've spent countless hours researching the forums and web. This Air encoder error has been going on for months! It's very dissapointing that there never seems to be an official manufacturer response or solution. All i have ever seen from the administrator is placations. I honestly don't think THEY know or have a soution .
Here is where I am as of this morning. I have replaced the sd card, reloaded everything from fthe Mavic firmware, Go 4 software, cleaned up all folders,reinstalled all drivers, new cables, using the dji provided ones now, recalibrated everything, re-linked/bound the drone to transmitter, developer mode, airplane mode and 1000 other things .............no joy.
By the way, I get it to work 1 time out of 10 disconnect/reconnect procedures mixing up the sequence of ONs. No sequence is absolute! The only thing I have done with any positive effect is switch mobile devices. I was using an older Samsung Galaxy Tab 4 and I think it was getting taxed toooooo much. I switched to a iPhone SE and while I still get similar errors, I am at 1 out of 3 or 4 connections. I want to upgrade the device even more and see what happens. This drone ROCKS...........every once in a while when it decides to work. This is why I like the FPV Racing drones using BF open source firmware.
I tried to get support to load fw version 400 so I could see if it would solve any issues. Absolutely no chance! Feels like dji is scared to let you go that far back and possibly have it work. |
|